Hallo,
der Lüfter von meinem iBook G4 800 springt immer wieder an und fängt langsam an mir auf den Keks zu gehen. cpufreqd hab ich laufen, hab die cpu im Ruhezustand auf 600MHz,.
Kennt jemand das Problem, bzw. hat jemand eine gute cpufreqd.conf für mich?
Lüfter vom iBook G4 geht dauernd an
- portishead
- Beiträge: 125
- Registriert: 02.07.2002 12:44:40
- portishead
- Beiträge: 125
- Registriert: 02.07.2002 12:44:40
- portishead
- Beiträge: 125
- Registriert: 02.07.2002 12:44:40
ich glaub nicht daß es bei mir funktionieren wird:
und ich hab nen PowerPC...
Code: Alles auswählen
It is designed for use with CPU's supporting AMD's PowerNow power management scheme, as it's algorithm works better if there are more then two CPU speeds available. (aka, ARM, AMD K6/K7, Via C3, and Crusoe as opposed to traditional Intel and Ultrasparc).
- peschmae
- Beiträge: 4844
- Registriert: 07.01.2003 12:50:33
- Lizenz eigener Beiträge: MIT Lizenz
- Wohnort: nirgendwo im irgendwo
/usr/share/doc/powernowd/README.gz
Andere Frage: Schweigt der Lüfter wenn du die CPU auf 600 Mhz (oder was das Minimum ist) festnagelst?
Also sowas:
MfG Peschmä
Sollte eigentlich schon gehen.This is a simple client to the CPUFreq driver that uses Linux kernel v2.5/v2.6
sysfs interface. You need a supported CPU and a kernel that supports
sysfs to run this daemon. The name is somewhat misleading, as this will work
with any CPUfreq capable processor, not just processors supporting AMD's
PowerNow! technology.
Andere Frage: Schweigt der Lüfter wenn du die CPU auf 600 Mhz (oder was das Minimum ist) festnagelst?
Also sowas:
Code: Alles auswählen
cd /sys/devices/system/cpu/cpu0/cpufreq
cat cpuinfo_min_freq > scaling_max_freq
- portishead
- Beiträge: 125
- Registriert: 02.07.2002 12:44:40
dell
hallo, habe da gleiche problem mit dell inspir 8500, obwohl /proc/acpi/thermal_zone/THM/temperatur mir "48" anzeigt (trip-points 90) läuft der lüfter permanent ohne unterbruch Leider klappt der install-prozess nicht so gut.
bin dankbar für einen tipp
rolf
apt-get install powernowd
powernowd: PowerNow Daemon v0.90, (c) 2003-2004 John Clemens
powernowd: Found 1 cpu:
Couldn't open file: No such file or directory
Couldn't open file: No such file or directory
Couldn't open file: No such file or directory
couldn't open govn's file for writing: No such file or directory
Couldn't get per-cpu data: Illegal seek
PowerNowd encountered and error and could not start.
Please make sure that:
- You are running a v2.5/v2.6 kernel or later
- That you have sysfs mounted /sys
- That you have the core cpufreq and cpufreq-userspace
modules loaded into your kernel
- That you have the cpufreq driver for your cpu loaded,
and that it works. (check dmesg for errors)
If all of the above are true, and you still have problems,
please email the author: clemej@alum.rpi.edu
kanotix bh7, kern2.6.6 / 2,2 ghz / sarge
bin dankbar für einen tipp
rolf
apt-get install powernowd
powernowd: PowerNow Daemon v0.90, (c) 2003-2004 John Clemens
powernowd: Found 1 cpu:
Couldn't open file: No such file or directory
Couldn't open file: No such file or directory
Couldn't open file: No such file or directory
couldn't open govn's file for writing: No such file or directory
Couldn't get per-cpu data: Illegal seek
PowerNowd encountered and error and could not start.
Please make sure that:
- You are running a v2.5/v2.6 kernel or later
- That you have sysfs mounted /sys
- That you have the core cpufreq and cpufreq-userspace
modules loaded into your kernel
- That you have the cpufreq driver for your cpu loaded,
and that it works. (check dmesg for errors)
If all of the above are true, and you still have problems,
please email the author: clemej@alum.rpi.edu
kanotix bh7, kern2.6.6 / 2,2 ghz / sarge