(vorher viewtopic.php?f=8&t=175322)
Hier gibt es aber kein Hardware_ECC_Recovered aber Fehlermeldungen am Ende:GTAzoccer hat geschrieben:06.11.2019 21:40:37Das ist bei einigen Herstellern normal. Die deklarieren erst mal alles gelesene als defekt und jagen es durch ECC. Solange die Werte Raw_Read_Error_Rate und Hardware_ECC_Recovered nicht voneinander abweichen, ist aber alles in Ordnung.
Code: Alles auswählen
smartctl 6.6 2016-05-31 r4324 [x86_64-linux-4.13.16-1-pve] (local build)
Copyright (C) 2002-16, Bruce Allen, Christian Franke, www.smartmontools.org
=== START OF INFORMATION SECTION ===
Model Family: Seagate Barracuda 7200.14 (AF)
Device Model: ST1500DM003-9YN16G
Serial Number: W1E2XX7T
LU WWN Device Id: 5 000c50 03cdf89c3
Firmware Version: CC4H
User Capacity: 1.500.301.910.016 bytes [1,50 TB]
Sector Sizes: 512 bytes logical, 4096 bytes physical
Rotation Rate: 7200 rpm
Device is: In smartctl database [for details use: -P show]
ATA Version is: ATA8-ACS T13/1699-D revision 4
SATA Version is: SATA 3.0, 6.0 Gb/s (current: 3.0 Gb/s)
Local Time is: Thu Oct 31 14:15:04 2019 CET
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x00) Offline data collection activity
was never started.
Auto Offline Data Collection: Disabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 584) seconds.
Offline data collection
capabilities: (0x73) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
No Offline surface scan supported.
Self-test supported.
Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: ( 169) minutes.
Conveyance self-test routine
recommended polling time: ( 2) minutes.
SCT capabilities: (0x3085) SCT Status supported.
SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 119 099 006 Pre-fail Always - 203973760
3 Spin_Up_Time 0x0003 095 095 000 Pre-fail Always - 0
4 Start_Stop_Count 0x0032 100 100 020 Old_age Always - 17
5 Reallocated_Sector_Ct 0x0033 100 100 036 Pre-fail Always - 0
7 Seek_Error_Rate 0x000f 072 060 030 Pre-fail Always - 103518000200
9 Power_On_Hours 0x0032 050 050 000 Old_age Always - 44147
10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 100 100 020 Old_age Always - 17
183 Runtime_Bad_Block 0x0032 094 094 000 Old_age Always - 6
184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0
187 Reported_Uncorrect 0x0032 092 092 000 Old_age Always - 8
188 Command_Timeout 0x0032 100 098 000 Old_age Always - 1 1 6
189 High_Fly_Writes 0x003a 099 099 000 Old_age Always - 1
190 Airflow_Temperature_Cel 0x0022 065 051 045 Old_age Always - 35 (Min/Max 26/37)
191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 0
192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 15
193 Load_Cycle_Count 0x0032 001 001 000 Old_age Always - 307699
194 Temperature_Celsius 0x0022 035 049 000 Old_age Always - 35 (0 23 0 0 0)
197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 0
198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x003e 200 183 000 Old_age Always - 308
240 Head_Flying_Hours 0x0000 100 253 000 Old_age Offline - 41659h+00m+23.594s
241 Total_LBAs_Written 0x0000 100 253 000 Old_age Offline - 29857006068967
242 Total_LBAs_Read 0x0000 100 253 000 Old_age Offline - 191416942922799
SMART Error Log Version: 1
ATA Error Count: 7 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 7 occurred at disk power-on lifetime: 43957 hours (1831 days + 13 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 78 ff ff ff 4f 00 43d+03:38:37.033 READ FPDMA QUEUED
60 00 08 ff ff ff 4f 00 43d+03:38:37.030 READ FPDMA QUEUED
60 00 08 ff ff ff 4f 00 43d+03:38:37.030 READ FPDMA QUEUED
60 00 08 ff ff ff 4f 00 43d+03:38:37.030 READ FPDMA QUEUED
60 00 08 ff ff ff 4f 00 43d+03:38:37.029 READ FPDMA QUEUED
Error 6 occurred at disk power-on lifetime: 42965 hours (1790 days + 5 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 00 ff ff ff 4f 00 1d+20:20:01.805 READ FPDMA QUEUED
60 00 00 ff ff ff 4f 00 1d+20:20:01.772 READ FPDMA QUEUED
60 00 00 ff ff ff 4f 00 1d+20:20:01.772 READ FPDMA QUEUED
60 00 00 ff ff ff 4f 00 1d+20:20:01.772 READ FPDMA QUEUED
60 00 00 ff ff ff 4f 00 1d+20:20:01.772 READ FPDMA QUEUED
Error 5 occurred at disk power-on lifetime: 42965 hours (1790 days + 5 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: WP at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
61 00 00 00 26 0b 40 00 1d+20:19:55.888 WRITE FPDMA QUEUED
61 00 18 ff ff ff 4f 00 1d+20:19:55.888 WRITE FPDMA QUEUED
61 00 08 ff ff ff 4f 00 1d+20:19:55.888 WRITE FPDMA QUEUED
61 00 20 e0 23 0b 40 00 1d+20:19:55.888 WRITE FPDMA QUEUED
61 00 10 ff ff ff 4f 00 1d+20:19:55.888 WRITE FPDMA QUEUED
Error 4 occurred at disk power-on lifetime: 42965 hours (1790 days + 5 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 00 ff ff ff 4f 00 1d+20:19:51.920 READ FPDMA QUEUED
60 00 00 ff ff ff 4f 00 1d+20:19:51.876 READ FPDMA QUEUED
60 00 00 ff ff ff 4f 00 1d+20:19:51.833 READ FPDMA QUEUED
60 00 00 ff ff ff 4f 00 1d+20:19:51.793 READ FPDMA QUEUED
60 00 00 ff ff ff 4f 00 1d+20:19:51.751 READ FPDMA QUEUED
Error 3 occurred at disk power-on lifetime: 38214 hours (1592 days + 6 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: WP at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
61 00 40 ff ff ff 4f 00 26d+22:44:04.270 WRITE FPDMA QUEUED
61 00 20 ff ff ff 4f 00 26d+22:44:04.269 WRITE FPDMA QUEUED
61 00 20 ff ff ff 4f 00 26d+22:44:04.268 WRITE FPDMA QUEUED
61 00 40 ff ff ff 4f 00 26d+22:44:04.268 WRITE FPDMA QUEUED
61 00 20 ff ff ff 4f 00 26d+22:44:04.267 WRITE FPDMA QUEUED
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Extended offline Completed without error 00% 11684 -
# 2 Extended offline Completed without error 00% 11675 -
# 3 Extended offline Completed without error 00% 11561 -
# 4 Extended offline Completed without error 00% 11555 -
# 5 Extended offline Completed without error 00% 11551 -
# 6 Extended offline Completed without error 00% 11475 -
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.