Ich hab die Frage wohl sehr unverständlich bereits in einem anderen Thread gestellt, möchte sie nochmals etwas klarer forumulieren :
Wie kann ich das Interface, über den der Traffic ins WAN geht, auf eth out einstellen, statt wie jetzt über USB 2.0?
Dazu muss man wissen das das Image für die Enigmabox an den Raspberry PI angepasst ist und dieser nur über einen Ethernet Anschluss verfügt. Ich jedoch besitze diesen Router :
http://www.bananapi.com/index.php/compo ... edit&id=59
Ich möchte also das Image anpassen, damit er über den Ethernet out routet, anstelle des USB 2.0 Anschlusses, welches den Traffic abbremst:
http://www.bananapi.com/images/R1/633x4 ... IOo9AX.png
Ich habe nur keine Ahnung, wie. Ich bin in derlei Hinsicht noch ein Totalanfänger und weiss nicht wo ansetzen. Das Image basiert auf OpenWRT.
In der Config Datei sehe ich folgendes :
Code: Alles auswählen
cat network
config interface 'loopback'
option ifname 'lo'
option proto 'static'
option ipaddr '127.0.0.1'
option netmask '255.0.0.0'
config interface 'eth0'
option ifname 'eth0'
option proto 'static'
option ipaddr '192.168.100.1'
option netmask '255.255.255.0'
option ip6addr 'xxxx::1/64'
config globals 'globals'
option ula_prefix 'xxxx:xxxx:xxxx::/48'
Code: Alles auswählen
netstat -nr
Kernel IP routing table
Destination Gateway Genmask Flags MSS Window irtt Iface
0.0.0.0 10.20.1.4 0.0.0.0 UG 0 0 0 tun0
xxx.xxx.xxx.xxx 192.168.0.1 255.255.255.255 UGH 0 0 0 eth1
xxx.xxx.xxx.xxx 192.168.0.1 255.255.255.255 UGH 0 0 0 eth1
xxx.xxx.xxx.xxx 192.168.0.1 255.255.255.255 UGH 0 0 0 eth1
xxx.xxx.xxx.xxx 192.168.0.1 255.255.255.255 UGH 0 0 0 eth1
xxx.xxx.xxx.xxx 192.168.0.1 255.255.255.255 UGH 0 0 0 eth1
xxx.xxx.xxx.xxx 192.168.0.1 255.255.255.255 UGH 0 0 0 eth1
xxx.xxx.xxx.xxx 192.168.0.1 255.255.255.255 UGH 0 0 0 eth1
xxx.xxx.xxx.xxx 192.168.0.1 255.255.255.255 UGH 0 0 0 eth1
xxx.xxx.xxx.xxx 192.168.0.1 255.255.255.255 UGH 0 0 0 eth1
192.168.0.0 0.0.0.0 255.255.255.0 U 0 0 0 eth1
192.168.100.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0