Hallo!
Ich habe hier Debian laufen. Nun muss ich noch für Windows Anwendungen noch Windows installieren. Windows habe ich schon auf einer 2. SCSI Festplatte installiert.
Windows ist somit auf Lazfwerk C installiert.
Debian ist auf meiner 1. Festplatte. Wie mache ich das, das ich mit lilo
Windows starten kann. Unter lilo
habe ich folgenden Eintrag:
other =/dev/sdb1
label=Windoof
Geht aber nicht, wie ich will. Rechner bleibt stehen.
Gruss Michael
Debian und Windows
Hmm, also bei mir schon
man lilo.conf
Normalerweise sollte diese Option doch auf dein Problem passen, oder übersehe ich da etwas?
Ansonsten poste doch mal die Fehlermeldung
Gruss
Ghost
man lilo.conf
Code: Alles auswählen
This flag (LILO version 22.5) indicates a DOS/Win
dows/OS2 or other system which will only boot from
BIOS device 0x80, the "C:" drive, or BIOS device 0,
the A: drive. When this flag is specified, if this
drive is not assigned device code 0x80 or 0 by the
BIOS, then the chain loader will dynamically swap
the device code actually assigned with device code
0x80 or 0 to make this drive appear to be the first
hard or floppy drive, "C:" or "A:".
This flag is easier to use than "map-drive=" (see
below), and is preferred, if simple forcing of
device code 0x80 is all that is required. It is
also more general, in that the necessity to swap
BIOS device codes is determined dynamically at
boot-time, not at boot install-time, as with "map-
drive=". It is slightly more powerful than "boot-
as=", in that the device code which is assigned, 0
or 0x80, is determined dynamically.
This option may by specified as a global option, in
which case it applies to all "other=" sections
unless overridden with a specific "boot-as="
option.
Ansonsten poste doch mal die Fehlermeldung
Gruss
Ghost