ich bekomme folgende "Fehler", wenn ich folgendes eingebe:
Code: Alles auswählen
fdisk -l /dev/hda
Code: Alles auswählen
Disk /dev/hda: 240 heads, 63 sectors, 833 cylinders
Units = cylinders of 15120 * 512 bytes
Device Boot Start End Blocks Id System
/dev/hda1 1 17 125181 82 Linux swap
Partition 1 has different physical/logical endings:
phys=(264, 14, 63) logical=(16, 134, 63)
Partition 1 does not end on cylinder boundary:
phys=(264, 14, 63) should be (264, 239, 63)
/dev/hda2 * 17 288 2050650 83 Linux
Partition 2 has different physical/logical beginnings (non-Linux?):
phys=(265, 0, 1) logical=(16, 135, 1)
Partition 2 has different physical/logical endings:
phys=(1023, 14, 63) logical=(287, 194, 63)
Partition 2 does not end on cylinder boundary:
phys=(1023, 14, 63) should be (1023, 239, 63)
/dev/hda3 288 560 2050650 83 Linux
Partition 3 has different physical/logical beginnings (non-Linux?):
phys=(1023, 14, 63) logical=(287, 195, 1)
Partition 3 has different physical/logical endings:
phys=(1023, 14, 63) logical=(559, 14, 63)
Partition 3 does not end on cylinder boundary:
phys=(1023, 14, 63) should be (1023, 239, 63)
/dev/hda4 560 833 2070967+ a5 FreeBSD
Partition 4 has different physical/logical beginnings (non-Linux?):
phys=(1023, 14, 63) logical=(559, 15, 1)
Partition 4 has different physical/logical endings:
phys=(1023, 14, 63) logical=(832, 239, 63)
Partition 4 does not end on cylinder boundary:
phys=(1023, 14, 63) should be (1023, 239, 63)
Ich verstehe das nicht, weil sowohl /dev/hda2 als auch /dev/hda3 sind eingebunden. Immerhin ist /dev/hda2 auch das root Dateisystem von Woody. Von beiden Partitionen kann ich lesen und auch darauf schreiben.
Dann sagt mir
Code: Alles auswählen
mount -t ufs -o ufstype=44bsd /dev/hda4 /mnt/hda4
Code: Alles auswählen
mount: wrong fs type, bad option, bad superblock on /dev/hda4,
or too many mounted file systems
Frage:Was verursacht die mount Fehlermeldung?
Ich hoffe wirklich, dass mir hier jemand weiterhelfen kann.
euer
debian_noob