Beitrag
von Lena12 » 04.09.2021 15:29:04
Hallo nochmal,
grade hatte ich das Problem, wenn ich meine Rechner gestartet habe, kam die Meldung "Selected boot image did not Authenticate. Press enter to continue"
Ich habe versucht die Startparameter die geladen werden abzuschalten, so wie in den vorherigen Kommentar dies erläutert wurde. Ich habe es so eingefügt wie es dran steht. Leider wurden mir die Parameter trotzdem angezeigt.
Danach habe ich ein installation von grub gemacht und ein update. Danach hab ich es neu gestartet und die Meldung wie oben beschrieben ist erschienen.
Das Problem habe ich dann so gelöst: Change from Secure Boot to Legacy Boot in Your BIOS Settings
You should change from Secure Boot to legacy boot in your BIOS settings. If you are sure that your computer cannot complete the start because of the virus or malware attack, then you can’t use this method; use method 3 instead. Here are the steps.
Step 1: You should enter the BIOS, read this post - How to Enter BIOS Windows 10/8/7 (HP/Asus/Dell/Lenovo, any PC).
Step 2: Press F10 to open the BIOS Setup when the Startup menu displays.
Step 3: Choose the System Configuration menu with the right arrow key, then select the Boot Option and press Enter.
Step 4: With the down arrow key, select Legacy Support and press the Enter button.
Tip: If it is disabled, you should select Enabled and press Enter.
Step 5: Then select Secure Boot and press Enter, then select disabled and press Enter.
Step 6: Press F10 to accept the changes and select Yes and press Enter.
The computer automatically reboots to Windows. Then you can check if the “selected boot image did not authenticate” error has been fixed. If not, you can try the next method.
Jetzt funktioniert es wieder ! Hat das irgendwelche Auswirkungen auf meine Sicherheit oder sonst etwas auf meinem System ?
Die Startparmeter werden immer noch angezeigt, irgendwelche Lösungen ?
Beste Grüße
Leni